CV Expander and jumper wires

2 posts / 0 new
Last post
jamespark
jamespark's picture
CV Expander and jumper wires

I installed the CV Expander to my Werkstatt so I could control it via CV with a Qunexus. I'd like to start doing some of the mods from this site. Most of the tutorials are using jumper wire. Is there a way I can use jumper wire while the CV Expander is installed or is my best bet stripping some 3.5mm mono cables on one end?

chrisdavidhowe
You could desolder the

You could desolder the original pins on the CV Expander and replace them with a "stackable" pin header, something like this.